M12x1.5 M12 1.5 1/8 NPT Oil Fitting Pressure Tee BMW "CRUSH WASHER INCLUDED"

This is an oil fitting that will allow you to adapt a turbo oil feed line or an aftermarket pressure gauge to your factory port on your  BMW or any other vehicle that relies on M12x1.5 factory threads.  Threads On the ends are M12x1.5 so you can screw it into your factory oil sending port and put the factory oil pressure switch in the female port to retain the factory gauge.  Then you have a 1/8 NPT port coming out (standard port for all aftermarket fittings) of the side which will allow you to use it for a feed for your turbo or you can use this as a port for your aftermarket oil pressure sensor.  This is the cleanest way to do this install, it removes having to piece together multiple fittings which looks unprofessional.  This piece is made out of steel and zinc finished to prevent corrosion.

Please do your own research to confirm this piece will fit your vehicle, but from all the research we've done it should fit all BMW's.  Please note though that it is your responsibility to confirm your vehicle uses these threads and also to ensure there is enough clearance to use this fitting.  Some vehicles have tight engine bays and you may not have the clearance to fit this.  Just look at where your current oil pressure switch/sensor is to validate there is enough room to add this fitting. The male threads are M12 x 1.5 as are the female threads on the opposite end. The female threads on the side are 1/8" NPT.

Brands this fitting SHOULD fit;

BMW

Mercedes-Benz

Audi

Some 2012+ Subaru/Toyota/Lexus